Standard wing cutting machines

Mechanics

Working area: 560 x 320 x 300 - 1450


Special measurements on request

2-phase stepping motor, 1.8° holding torque 15 Ncm Power transmission trough ball-bearing driven trapezoidal thread and toothed belts, linearity through fiction bearings on precision shafts, mounts made of aluminum

Motor Control Unit: 4-axes chopper drive with half step output (400 steps/r), four pulse and direction inputs, select input for cutting off power of all four axes, power supply 230 V / AC 50 W (115 V / AC available), dimensions 225 x 190 x 55 mm, connection to the STEP-FOUR transformer.

Transformer with full electronic control for constant wire temperature while cutting. The interface to the drive unit allows a reference value output directly via the STEP-FOUR® software. Input power: 230 V/AC 50 Hz (115 V/AC 60 Hz), output power: 0 to 6A via handwheel or via PC-interface in 25mA steps, analog power display, switch for manual or automatic operation, short-circuit protected, cutting-wire resistance min. 2 Ohm, connection of the cutting-wire via 4mm banana jacks/plug, output power: max. 160 VA, environment temperature: 0-40°C, dimensions: 230 x 185 x 95 mm.


STEP-FOUR PC-CUT Standard Fact-sheet of PC CUT Standard - German version only

STEP-FOUR milling units comply with the highest safety standards and are CE - certified.